Arduino DC Motor Chat Control
DC motors can be controlled by the L298N DC motor driver IC, which is connected to your microcontroller. L298Ns can control up to 2 DC motors. You can easily add motors through the program code. You can set DC motor speed by changing the duty-cycle of each PWM signal. The PWM is a square-wave signal which has two parameters: frequency and duty-cycle. If a PWM signal's duty-cycle is 100% than the motor spins with maximum rpm. In case of 0% the motor will stop. Motor speed and direction in your Ozeki software can be changed on each motor with the motor's own adjustable slide bar from -100% to 100%. If the slide crosses 0 than the motor will change spin direction.
You can chat with the device at the Ozeki 10 as the video shows below.
Possible commands
More information
- How to setup a dc motor on arduino mega
- How to setup a dc motor on arduino nano
- How to setup a dc motor on arduino uno
- How to setup a dc motor on Ozeki matrix
- How to setup a dc motor on Raspberry Pi
- DC motor protocol for arduino
- How to control a dc motor using chat messages
- DC Motor Arduino
- DC Motor Desc