How to make an arduino nano case from cardboard

Download the PDF of the box: Arduino nano case from cardboard template.pdf

The Arduino Nano is a small, complete, and breadboard-friendly board based on the ATmega328 (Arduino Nano 3.x) or ATmega168 (Arduino Nano 2.x). For storing it or protecting your board from any environmental impacts, or if you want to hide its components to make it more aesthetic, it is a practical solution to make a box for it. The following DIY Arduino Nano case project presents step-by-step how to create a handy box within a few minutes.

Contents

  1. What is needed to make an Arduino Nano case
  2. Step 1 – Download and print out the PDF template of the box
  3. Step 2 – Cut out the template of the box
  4. Step 3 – Fold the box along the folding lines

What is needed to make an Arduino Nano case

Here is a checklist for getting ready to make an arduino nano case:

  • PDF template of the box downloaded on your PC
  • One piece of A4 cardboard (ideal paper weight: 200-250g)
  • Printer
  • Scissors, cutter

Step 1 – Download and print out the PDF template of the box

To make a perfectly fitting box, first you need to download and print out the PDF template of the Arduino Nano case (download link: Arduino nano case from cardboard template.pdf). The template is absolutely free and available for anyone.


Download the PDF template of the Arduino Nano case

For printing, you need a piece of A4 cardboard. A 200-250g weight cardboard works best for this project, though other similar papers like glossy or matte photo papers work just fine, too.


Print the template of the box on a piece of A4 cardboard

Step 2 – Cut out the template of the box

After printing out the template of the box, you can see the net (the unfolded surface) of the box. The template contains dashed and solid lines as well. Please, take care that you need to cut along the solid lines, while dashed lines indicates the place of folding. So please, do not cut the dashed lines.


Cut out the template along the solid lines

When cutting out the cardboard, it is worth taking the time to perfectly cut out the tiny holes and gaps. It is recommended to use a small sharp scissors (such as nail scissors) or rather a cutter.


Cut out the tiny holes and gaps carefully

Step 3 – Fold the box along the folding lines

Once your template is cut out, fold the cardboard along the dashed lines. When the edges are completely matched, softly press the fold with your fingers, and then crease with a bone folder (or a simple ruler) to make the fold permanent. When opened up, you cardboard should look like this:


Fold the cutted template along the solid lines

You are done the folding! Now it is time to tuck in the edges and form the box. For this purpose, use the following markings that help you while reading the instructions below:


Supplementary markings to form the box

With the template opened up, fold the tabs marked with ’A’ (Figure 6) up. Now keep the side marked with ’Bottom’ on the table, and then fold each adjacent side up. Tuck in the tabs marked with ’B’. For making your folds well-fixed, be sure that the tiny tongues on the ’B’ marked tabs perfectly match into the cuts under them.


Form the box by tucking in the side panels

Now place the Arduino Nano board into your box as you can see below:


Place the Arduino Nano board into your box

Finally, fold down the side marked with ’Up’ (Figure 6) while tucking its two tabs into the box. The only thing you left to do is pushing the last small tongue into the hole made previously on the ’Up’ marked side.


The completed Arduino Nano case

Congratulations, you made a perfectly fitting box for your Arduino Nano board!

More information